These clips can be brittle and break so be gentle.
2004 chevrolet silverado changing the drivers side blend door actuator.
Remove the 7mm screw from the driver s side of the cross over bracket.
I removed the new one and tried seeing if the actuator would move when adjusting temp.
Inspect the connector for rust or corrosion and clean as needed.
Begin by using a small screwdriver to release the wiring safety clip on the harness for the actuator.
To see which blend door is t.
Once released gently pull down on the wiring connector and remove it from the blend door actuator.
My a c was stuck on just hot but this.
I successfully removed the old and installed the new.
It was still blowing hot out of the driver s side.
Remove the 7 mm screws on the driver s side bracket.
Replacing the driver side blend door actuator acdelco 1572972 and reseting the blend doors for the front a c system.
In this video we show how to replace the blend door actuator that controls the heat and cold in a 1999 2007 chevrolet silverado.
It seems like the actuator is being told to turn the shaft to heat.