Best Way To Get Paint Off Of Cedar Shingle Siding

Stains dry rapidly and fresh stain applied over dried stain will show lap marks.

Best way to get paint off of cedar shingle siding.

Has anyone run into a similar situation. If the stripping compound has enough time to finish its work it. If one chooses to spray the paint on the cedar the best results will be achieved by back brushing the finish during application. Certain areas are peeling and lifting and the color has faded.

Staining cedar siding differs from application of paint and other finishes. When the wood goes through a series of wet dry periods the paint and finish are stressed and the paint can crack. Shingle siding house with massive paint failure. Cedar is a soft wood and the force of a power washer while it will take the paint off easily enough will also very likely damage the wood and drive moisture deep into it causing your future paint job to peel off later.

For refinishing especially hand brushing is always preferred. Begin scraping off the mixture of paste and paint using the paint scraper. With a porous material like cedar the main idea is to apply a greater quantity of paint to the wood and hand brushing is the best way to accomplish this. After years of being painted exposed to the elements and painted again the paint on cedar will begin to crack and peel.

First remove any mill glaze a hard shiny surface on one side of the siding by sanding. But over time the elements have taken their toll and the finish is starting to look weathered. I usually rely on a paint shaver for step 3 which will not work on rough cedar shakes. Painted shingles look great for the first two to three coats of paint.

Your freshly painted cedar siding looked so good after it was completed. The best way to remove paint from lap board siding. Peeling paint was removed by cross scraping with carbide hand scrapers then stripped to bare wood with port. The key to a successful application of paint is surface preparation.

Cedar is commonly used for outdoor furniture roofing and for shingles on the outside of a home. I see that wagner makes a tool called the paint eater that uses a small 3m abrasive disk and was wondering if this is a possible solution. 3 scrape sand to remove any loose paint and feather the edges.